Help by platform

Huawei HiSilicon OLD series

Unlock

Direct unlock
Unlock SIM BLOCK
Direct unlock for Mediapad M1 and X1 devices on HiSilicon Balong

FRP and Huawei ID Remove:

FRP Remove via fastboot mode
FRP Remove via ADB mode (Works up to March 2018 security patch level)
Huawei ID remove via Manufacture Mode (old security versions)
Huawei Bootloader Password Reading (old security versions)

Service

Repair IMEI in Manufacture mode (older models)
Repair IMEI for Mediapad M1 and X1 devices on HiSilicon Balong
Fix "Software IMEI: Not found" issues

Flash:

Enable downgrade via Manufacture mode
Repair of Wi-Fi, Bluetooth and Serial Numbers
Enable Manufacture Mode
FLASH via fastboot mode (only for reviving of bricked devices)
UPGRADE MODE flashing
Flashing / Downgrading using full OTA UPDATE files


Reminder! Before servicing the phone, please make sure that:

  1. You use the latest version of Smart-Clip2 software
  2. Battery must be connected to the phone's board and fully charged. Especially while performing operations using testpoint.
  3. Huawei devices with latest security versions: you will have to use hardware testpoint and modified USB cable.
  4. All the side programs, that may interfere with the phone, are closed
  5. Phone’s cable and device itself should not be disconnected or disturbed until the procedure is fully completed
  6. Connect phone to USB port placed on the backside of PC (motherboard's USB port)
    Do not connect or disconnect other USB cables into the PC during the actual work with the phone
  7. Avoid using any kind of USB HUBs and long USB cables. Use the shortest-length USB cable available.
  8. Phone has stock (factory) firmware version
  9. SIM card is removed